Compare products

Make distortion free cuts with the IT-7700N and IT-7701. The blades shear the material giving a clean cut. A 1/4” strip of material is removed by the cutting action or can be used to trim one edge. Loosen one screw to rotate head 360 degrees.

Ratchet wrenches are exceptionally good at doing the job they are designed for – removing fasteners after they have first been loosened. It is important to keep the ratchet mechanism clean and free of sand and grit. Sand will wear out the ratchet mechanism and cause premature tool failure. Use an air blow gun to clean the head after extended use.

The IT-8758R and IT-8759R are the .35 HP version of the IT-8859R. With plenty of power and their smaller size, these tools are a must for production grinding. As with all die grinders, use of balanced stones and accessories are required. Also using a maximum of 90 PSI at the tool and oiling daily at the end of each shift will give extended life to the tool.

Quality drills for production use. The IT-7768R has a convenient forward and reverse lever, rear exhaust and all ball bearing construction. Comes standard with a quality drill chuck with a range of 0 to 3/8” and superior holding power. Variable speed and three gear system make this our best 3/8” drill. IT-7768 is the same great tool in forward only.

The 1/4-28 Drill Motors shown here give a wide range of use for tight spots encountered in aircraft manufacturing and any type of production drilling situation.

Replacement 5″ pad for IT-7815A

*Built in regulator
*Lightweight aluminum
*Lock off lever
*Rear exhaust
*IT-7002A44 Carbide Wheel included

Straight Handle Rivet Gun, .401 Shank Rivet Gun.

(uses our IT-9801341 4” Cutoff Wheel) same great tool as the IT-8801REX, but with short reach

5” DA Pad for use with IT-7555VAC Spindle size 5/16-24 PSA vinyl face.

The IT-7315 removes material from large areas with ease. The synchronized dual pistons give a smooth action that reduces operator fatigue.

*Positive lock clips hold paper in place
*Rubber grip absorbs shock
*One hand operation
*1/8” orbit for fine work

Used for wet or dry sanding. Great for fiberglass, plastic, steel, aluminum, or wood. A must for every body shop and woodworking shop.

The IT-9555 & IT-9556 sanders are our smoothest running DA Sanders. Metal rotors and fiberglass pads help to improve cutting action and durability.

Small and easy to use, the IT-7702 cuts straight and curved shapes. Cuts aluminum, mild steel, plastic and fiberglass with ease. Comes with two blades (24 & 32 TPI).

*.7 HP motor provides fast efficient grinding in tight spots
*Hardened spiral bevel gears in angle head for long life and low vibration
*Lock off lever standard
*Uses type 27 grinding wheels (not included)
*Built-in governor prevents overspeed

The IT-8826 is a super stubby 3/8” Ratchet Wrench that fits in the palm of your hand.
A 1/4” hex hole in the anvil will accept 1/4” Apex screwdriver bits. The convenience of this tool is hard to believe, reaching into places like no other.

Adapter has male thread 5/8-11.

The perfect tools for cleaning and polishing dies, porting and polishing engines, de-burring castings and any job where carbide burrs or stones are used for delicate material removal. The IT-7401 now comes in a storage case with oil bottle, quick disconnect fitting, IT-5830 oiler and 2 collet wrenches.