Compare products

The perfect tool for removal of dried out gasket material.
The IT-7703 will not harm underlying surface when using at the correct angle.

Ratchet wrenches are exceptionally good at doing the job they are designed for – removing fasteners after they have first been loosened. It is important to keep the ratchet mechanism clean and free of sand and grit. Sand will wear out the ratchet mechanism and cause premature tool failure.

A great tool for heavy duty scaling, the IT-7601 has a well cushioned rubber handle, heat treated piston and barrel.

Plenty of power for the toughest jobs. Will drive pins, cut sheet metal, scrape or cut steel, aluminum, wood, stone or concrete. The IT-7151 has a longer stroke and heavier piston. The IT-7111 has a shorter stroke and piston and higher BPM making it more suitable for panel cutting.

• Built-in regulator
• Long life twin hammer clutch
• Ring type socket retainer
• High performance motor
• Light weight aluminum handle
• Comfort grip
• Convenient forward and reverse

(specify 5″ or 6″ pad)

IT-7311/IT-7311W5

*Built-in Regulator
*1/2 HP motor
*Full ball bearing construction
*Built-in silencer
*Balanced counter weight design
*Locking shaft for easy pad removal
*Available with Velcro pad (specify when ordering)
*3/8” Orbit

The 1/4-28 Drill Motors shown here give a wide range of use for tight spots encountered in aircraft manufacturing and any type of production drilling situation.

IT-7788-A 3/8” Standard Jacobs Multicraft Drill Chuck. 3/8-24 threads. Key is model IT-7788-B. Chuck and key are model IT-7788-C. This chuck can be used on forward and reversible drills. Capacity 3/8″

6” DA Pad 5/16-24 for the IT-7311, IT-7446 and IT-7786. Has velcro face for abrasives with the hook and loop system.

Non-reversible, The IT-9888 is a quality 1/4” drill with the teasing throttle control you need. Multi directional exhaust cover channels exhaust away from user. Quiet and comfortable, the cushioned grip and quiet operation makes this the perfect 1/4” Palm Drill. Shown with precision 1/4” chuck. Also available with 1/4” Composite Keyless chuck as IT-9888K, with 1/4” Metal Keyless chuck as IT-9888MK and with 1/4” Hi-Precision Geared chuck as IT-9888SPC.

The IT-8816 is excellent for shaping and contouring patches, sanding body filler and for heavy rust removal. Comes complete with
a foam 7” Velcro Pad – (IT-881647V). Sanders come with blue grip and run at 5500 RPM. Polishers have a red grip and are 2500 RPM. The IT-8816 & IT-8816P have all the bells and whistles – Rear exhaust – lock off levers – cushion grips – foam pads – low noise – grease fitting in head.

Our One Shot hammers are designed for operations requiring less power, including driving oil seals, bushings and pins. Every pull of the lever delivers a single blow that can be regulated by adjusting the air pressure.

IT-7768R41BA-A 3/8” Special Jacobs 41BA Drill Chuck. 3/8-24 threads. Key is model IT-7768R41BA-B. High quality machined gear. Chuck and key are model IT-7768R41BA-C. This chuck can be used on forward and reversible drills. Capacity 3/8”.

Manual torque adjustment – tighten or loosen internal spring

The IT-9915 series of grinders are built for production and long life. Adjustable exhaust, Heavy duty safety lockoff lever. Use type 27 wheels (not included).