Compare products

The IT-8816 is excellent for shaping and contouring patches, sanding body filler and for heavy rust removal. Comes complete with
a foam 7” Velcro Pad – (IT-881647V). Sanders come with blue grip and run at 5500 RPM. Polishers have a red grip and are 2500 RPM. The IT-8816 & IT-8816P have all the bells and whistles – Rear exhaust – lock off levers – cushion grips – foam pads – low noise – grease fitting in head.

Our One Shot hammers are designed for operations requiring less power, including driving oil seals, bushings and pins. Every pull of the lever delivers a single blow that can be regulated by adjusting the air pressure.

The IT-8826 is a super stubby 3/8” Ratchet Wrench that fits in the palm of your hand.
A 1/4” hex hole in the anvil will accept 1/4” Apex screwdriver bits. The convenience of this tool is hard to believe, reaching into places like no other.

Make distortion free cuts with the IT-7700N and IT-7701. The blades shear the material giving a clean cut. A 1/4” strip of material is removed by the cutting action or can be used to trim one edge. Loosen one screw to rotate head 360 degrees.

*Built-in Regulator
*1/2 HP motor
*Full ball bearing construction
*Built-in silencer
*Balanced counter weight design
*Locking shaft for easy pad removal
*Available with Velcro pad (specify when ordering)
*3/8” Orbit

Make distortion free cuts with the IT-7700N and IT-7701. The blades shear the material giving a clean cut. A 1/4” strip of material is removed by the cutting action or can be used to trim one edge. Loosen one screw to rotate head 360 degrees.

Tool comes standard with one head, either 6-32, 8-32, 10-24, 10-32, 1/4-20, 5/16-18, M3, M4, M5, M6 or M8. Additional heads available separately.

The IT-7665 is small, compact and easy to use. It features heavy-duty ball bearing construction, built-in regulator and a smooth powerful cutting action. The vinyl face pad makes for easy attachment of PSA sandpaper. Pad size is 90 x 90 x 80mm. Triangular Pad allows use in corners and tight spots. The 1/8” Orbit gives a fine finish and heavy cutting action for the most demanding work. Can be used for sanding, polishing and scrubbing.

The IT-5540 precision 3/8” non reversing drill features smooth two speed throttle, strong .7 HP motor, side handle for right or left hand use, quiet rear exhaust and roller bearings in the gears. Choose from three drill chuck options.

Both tools are lightweight, powerful production routers. Easily adjustable. Direct drive motors have no gears to wear. Complete with lock off levers and rear exhaust. All aluminum router base.

Straight Handle Rivet Gun, .498 Shank Rivet Gun.

This unique shredder has many uses. The roller on the back of the tool acts as a pivot point so that more or less pressure can be applied. Carbide wheel cuts fiberglass, concrete, wood, plastic and many other materials.